2″-12″ Linear Actuator

2″-12″ Linear Actuator

0 out of 5


The Creative Werks Inc. LD Series actuators are built on a small frame and used primarily to open and close devices in tight or hard to reach areas.

  • Description
  • Additional information


This actuator is configurable to meet many applications; options include potentiometer, IP65 Ingress protection and 5 different gear ratios. Linear actuators are gear-driven drive motors that extend the shaft with 107 lbs. of force and have a 500 lb static load.   Our actuators are compatible with our remote control systems and switches, allowing for custom installation and operation in countless applications. With built-in limit switches & ACME drive system they are ideal for automotive applications.

The potentiometer allows you to preset specific stopping points with the actuator’s line of travel. Using our controller, you can pre-set up to three specific stopping locations.

Input Voltage 12VDC
Max Push/Pull 110 lbs
Static Load 500 lbs
No Load Speed 0.59 in/sec
Max Load Speed 0.39 in/sec
Stroke Length     2.16″    4.01″    5.90″    7.93″   10.00″  11.96″
Retracted Length     6.36″    8.13″   10.10″   12.07″   14.03″  16.00″
Extended Length     8.52″    12.19″   16.00″   20.02″   24.01″  27.97″
Duty Cycle 20%
IP Grade IP 65 – Totally protected against dust.  Protected against low pressure water jets if water from all directions.  Limited ingress permitted.

We have additional linear actuator sizes, mounting brackets and controllers available.

Additional information

Weight 4 lbs
Stroke Length

2", 4", 6", 8", 10", 12", 18"

With Potentiometer

Yes, No